RST Ecoenergy Pvt. Ltd.Innovating the Future
FREE ENGINEERING TOOLS / Fabrication tools

Free Metal Weight Calculator

Calculate MS, stainless steel, aluminium, copper and brass weight for sheets, plates, pipes and structural profiles. Free online kg and material-cost estimates.

01 / MATERIAL & PROFILE

What are you calculating?

02 / DIMENSIONS

Enter the dimensions.

How this calculator works

Mass = cross-sectional area × length × density. All dimensions are converted to metres before calculating kilograms.

Use your actual inputs

Material densities and operating factors are editable planning assumptions. Replace them with supplier data or measurements for the configuration you intend to use.

Keep calculations inspectable

Inputs, units and results are shown together. Save a CSV or print the calculation to share your planning assumptions.

Need help with an RST product or a custom configuration? Discuss your requirement ↗

Why can purchased weight differ from calculated weight?

Thickness, dimensional tolerance, alloy density, radii and coatings can affect the actual weight. The optional actual total weight is reported separately with its difference from the theoretical value. Channel, angle and I-beam calculations use ideal sharp-corner geometry.

FREE TOOL / PRACTICAL GUIDE

How to use the Metal Weight Calculator.

Use this free metal weight calculator to estimate the theoretical mass of a sheet, plate, round bar, square bar, pipe, rectangular tube, angle, channel or I-beam. Choose a material or enter your own density, then compare the result with actual purchased weight.

  1. Choose the material and confirm its density. Select the profile and a dimension unit: mm, cm, m or inches.
  2. Enter the dimensions and quantity. Add a rupee-per-kg rate if you want a material-cost estimate.
  3. Calculate, inspect the assumptions, then download the CSV or print the result. Enter measured purchased weight separately to compare the difference.

Worked example

Example: a mild-steel plate 1,000 mm × 1,000 mm × 1 mm at a density of 7,850 kg/m³ weighs 7.85 kg theoretically. Ten identical plates weigh 78.5 kg before allowing for actual dimensional tolerances.

MS sheet, pipe या aluminium का अनुमानित वजन निकालने के लिए material, dimensions और quantity भरें। Actual purchased weight अलग डालकर तुलना भी कर सकते हैं।

Frequently asked questions

How do I calculate steel plate weight in kg?

Convert length, width and thickness to metres, multiply them to obtain volume in m³, then multiply by density in kg/m³. For the example above: 1 × 1 × 0.001 × 7850 = 7.85 kg.

Can I calculate aluminium or stainless-steel weight?

Yes. Select the material and check its nominal density. Alloy grades differ, so replace the default density with a supplier value when accuracy matters.

Why is actual purchased weight different?

Manufacturing tolerances, wall thickness, section radii, coatings and alloy composition affect measured mass. Structural-profile results use simplified geometry. The theoretical result does not replace a weighbridge or supplier certificate.

ENGINEERED IN INDIAIndigenous development. Indian ambition.

Specialised lighting, electronics and engineering—supporting the spirit of Atmanirbhar Bharat.

RST ECOENERGY

Request a quotation

Open the quotation form as a full page ↗

RST CREDENTIALS & RESOURCES

Request document download

Open request as a full page ↗